Stainless Steel Tactile Pads

Stainless Steel Tactile Pads

PRODUCT CODE: 400

 

 

APPLICATION

 

 

Our full range of commercial tactiles are suitable for internal and external applications. Integrated tactiles are easy and quick to install, simply prepare the surface and screw and plug. The durable stainless steel tiles are designed to be used immediately.

Stainless Steel Tactile Pads are…

  • Meets AS / NZ safety standard AS1428.4.1-2009
  • Available with silicon carbide infill
  • Durable and hardwearing
  • High grade  316 marine grade stainless steel
  • Very high resistance to mechanical damage, shopping trolly wheels, blunt force impact, Vehicles driving over them, vandalism etc.

Categories: ,

Description

The benefits from the Allway’s Stainless Steel Tactile plates are that the Tactile Indicator studs are fixed through the 316 Stainless steel plate and fully welded. This assures the tactile cannot be forced off or be removed. Can be installed on most types of surfaces and looks aesthetically pleasing. The plates are corrosion proof and the tactiles have been anti-slip rated R13 – P5

 

Installation Methods

Make sure you remove any debris & dust and make sure the surface is completely dry.

IMPORTANT: Please use the Surface Primer supplied. It is advisable to keep the pads warm as this will assist in achieving an instant bond. The warmer they are the better the adhesion will be.

  1. Place the Tactile pads into position leaving a 1-2mm gap for expansion.
  2. Apply masking tape as close as possible to around the edges of the pads
  3. Remove pads and apply the Surface Primer onto the surface and up to the edge of the masking tape allowing the primer to soak in.
  4. Leave primer to dry between 15 – 30 minutes pending on conditions.
  5. Remove backing paper from the tactile pad and place into position leaving a 1-2mm gap. Tap down firmly with rubber hammer.
  6. Once the area is completed remove the masking tape

Compliance

Allway’s self-Stick Tactiles comply with the following standards:

  • National Construction Code
    •  Section D3.8
  • Australian/New Zealand Standard 1428.1 2009 – Design for access and mobility – Design for access and mobility: General requirements for access – New building works
  • Australian/New Zealand Standard 1428.4.1 2009 – Design for access and mobility – Means to assist the orientation of people with vision impairment: Tactile ground surface indicators
  • Australian/New Zealand Standard 4586 – 2013 – Slip resistance classification of new pedestrian surface materials

Luminance Contrast

The Building Code of Australian/New Zealand and the AS/NZS 1428.4.1 require a minimum luminance contrast of 30%. Guide lines are as follows:

  • Integrated tactile indicators – not less than 30% across the entire area
  • Discrete (individual) tactile indicators – not less than 45%
  • Where Discrete tactile indicators are constructed of two colours or materials the raised section shall have a minimum contrast of 60%

Test – AS.NZS 1428.4.1 2009 Appendix E (pg 70-77)